Old Project Avalon Forum (ARCHIVE)

Old Project Avalon Forum (ARCHIVE) (http://projectavalon.net/forum/index.php)
-   Preparations / Advice (http://projectavalon.net/forum/forumdisplay.php?f=50)
-   -   Food Storage Tips - Preventing Corrosion of Canned Goods (http://projectavalon.net/forum/showthread.php?t=8693)

Baggywrinkle 12-07-2008 03:59 PM

Food Storage Tips - Preventing Corrosion of Canned Goods
 
Food Storage Tips - Preventing Corrosion of Canned Goods
Many areas have difficulty storing metal canned goods for long periods of time. This is usually caused by very high humidity levels, exposure to moist, salty air in a coastal environment or storage in basements or cellars with high humidity. If this is a problem, it is possible to extend the life of metal cans by coating the outsides of the cans. There are several different ways in which this can be accomplished.

Paste Wax Method

Combine 2 to 3 ozs. of paste wax with a quart of mineral spirits. Warm the mixture carefully in its container by immersing it in a large pot of hot water. Stir the wax and mineral spirits thoroughly until it is well mixed and completely dissolved. Paint the cans with a brush making sure to coat all seams and joints. Place the cans on a wire rack until dry. DO NOT HEAT OVER AN OPEN FLAME!

Paraffin Method

Using a double boiler, paraffin is melted and brushed onto clean, rust free cans. Make sure to get a good coat on all the seams and joints. If the can is small enough, it can be dipped directly into the wax. Be careful so as not to cause the labels to separate from the cans. Do not leave in long enough for the can to get warm. Afterwards, place on a rack to dry.

Spray Silicone Method

A light coating of ordinary spray silicone may be also used to deter rust. Spray lightly, allow to dry, and then wipe gently with a clean cloth to remove excess silicone.

Clear Coating Method

A clear type coating may also be sprayed or brushed on the seams and joints of the cans. This is best suited for larger re-sealable cans, but it will keep your canned goods protected from corrosion for years.

Tez 12-08-2008 01:41 AM

Re: Food Storage Tips - Preventing Corrosion of Canned Goods
 
Good info here, thanks.

I had heard of the parafin method, but had not come across the others.

Tez

Humble Janitor 12-08-2008 02:13 AM

Re: Food Storage Tips - Preventing Corrosion of Canned Goods
 
Can you also keep the food in them from going bad besides storing them properly?

I prefer dehydrated foods such as jerky, dried fruit, etc.

Baggywrinkle 12-08-2008 02:15 AM

Re: Food Storage Tips - Preventing Corrosion of Canned Goods
 
Quote:

Originally Posted by Humble Janitor (Post 92147)
Can you also keep the food in them from going bad besides storing them properly?

I prefer dehydrated foods such as jerky, dried fruit, etc.

I was working in an old building and found peppers and tomatos home canned in glass. They were AT LEAST thirty years old. When I opened one it still smelled good

Gnosis5 12-08-2008 02:17 AM

Re: Food Storage Tips - Preventing Corrosion of Canned Goods
 
How about vaseline jelly?

elsinorelore 12-08-2008 07:54 AM

Re: Food Storage Tips - Preventing Corrosion of Canned Goods
 
Yes, what about vaseline? I thought I had read that somewhere too? Any other easier methods? I cant get some of the original suggestions where I live.

Baggywrinkle 12-08-2008 07:58 AM

Re: Food Storage Tips - Preventing Corrosion of Canned Goods
 
Quote:

Originally Posted by elsinorelore (Post 92245)
Yes, what about vaseline? I thought I had read that somewhere too? Any other easier methods? I cant get some of the original suggestions where I live.

Any coating that will not dry out or wear off will serve.
Paint might also work. But then how would you read the
label?


All times are GMT. The time now is 07:28 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Project Avalon